Installation
INSTALLATIONWARNING:
Always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" before performing service on the airbag module.
1) Align the center position of the roll connector.
2) Install each part in the reverse order of removal.
CAUTION:
Insert the roll connector guide pin into the guide hole on the lower end of the steering wheel surface. Avoid damaging the pin.
NOTE:
Align the alignment marks on the steering wheel and steering shaft.
Tightening torque:
39 Nm (3.98 kgf-m, 28.8 ft-lb)
Column cover-to-steering wheel clearance:
2 - 4 mm (0.08 - 0.16 in)