Fog/Driving Lamp: Service and Repair

Front Fog Light Assembly

REMOVAL

1. Disconnect the ground cable from battery.
2. Lift up the vehicle.
3. Remove the screw and clips, and turn over the front side of the mud guard - front.






4. From the bottom of the bumper face - front, remove the fog light assembly - front.
1. Disconnect the connector.
2. Remove the bolts, then remove the fog light assembly - front.






INSTALLATION

1. Install each part in the reverse order of removal.

Tightening torque:
Fog light assembly - front: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

2. Adjust the fog light beam.