Turn Signal Light & Hazard Light Module
Turn Signal Light & Hazard Light ModuleINSPECTION
On- the vehicle inspection
Preparation tool: Circuit tester
1. Disconnect the turn signal and hazard module connector.
2. Measure the voltage between the turn signal & hazard module connector and the chassis ground.
Repair or replace the harness if the inspection result is not within the standard value.
3. Measure the resistance between the turn signal & hazard module connector and the chassis ground.
Repair or replace the harness if the inspection result is not within the standard value.
4. Connect the turn signal and hazard module connector.
5. Measure the voltage between the turn signal & hazard module and the chassis ground.
Replace the turn signal and hazard module if the inspection result is not within the standard value.