Brake Light Switch: Service and Repair

BACK UP LIGHT SWITCH

WARNING: Refrain from work while exhaust center pipe is hot.


REMOVAL AND INSTALLATION

NOTE: When replacing switch, use care not to let dust enter transmission through switch hole.

1. Lift up vehicle.





2. Remove coupler(s) for switch wiring.





3. Replace switch, connect and clamp as they were.
Tightening Torque
(a): 20 Nm (2.0 kg.m, 14.5 ft. lbs.) (Type 1)
(a): 45 Nm (4.5 kg.m, 32.5 ft. lbs.) (Type 2)
4. When back up light switch has been replaced, check switch for proper function with ignition switch turned ON and gear shifted to reverse position. Turn OFF switch after checking its function.