Toothed Ring Replacement

Removal





1. Remove rear axle shaft assembly.
2. In order to remove sensor rotor (retainer ring) (2) from shaft (1), grind with a grinder one part "A" of the sensor rotor (retainer ring) as shown till it becomes thin.

CAUTION:
- Cover vinyl sheet (3) or the like over wheel bearing so that fine grains from grinding will not enter there.
- Be careful not to go so far as to grind the retainer ring.





3. Break with a chisel (1) the thin ground sensor rotor (retainer ring), and it can be removed.

Installation





1. Press-fit sensor rotor (retainer ring) (1) as shown in the figure.
2. Install rear axle shaft assembly.