Scan Tool Data Definitions

Scan Tool Data Definitions

Vehicle Speed (km/h, mph) This parameter indicates the vehicle speed computed by ECM.

Outside air Temp (degrees C, degrees F) It is detected by outside air temperature sensor.

Battery Voltage (V) This parameter indicates battery positive voltage inputted to BCM.

Coolant Temp(Engine coolant temperature) (degrees C, degrees F) This parameter indicates the engine coolant temperature computed by ECM.

Engine Speed (RPM) This parameter indicates the engine speed computed by ECM.

Fuel Consumption (km/l) This parameter indicates the fuel consumption computed by ECM.

Key Reminder Sw (Key reminder switch) (Pulled / Key in) This parameter indicates the state of the key reminder switch.

Door key Sw (Door key cylinder switch) (Lock / Neutral / Unlock) This parameter indicates the state of the door key cylinder switch.

Door lock Sw (Manual door lock switch) (Lock / Neutral / Unlock) This parameter indicates the state of the manual door lock switch.

Driv Door Sw (Driver side door switch) (Open / Close) This parameter indicates the state of the driver side door switch.

Pass Door Sw (Other than driver side door switch) (Open / Close) This parameter indicates the state of the door switches other than driver side door switch.

Brake Fluid Level (Low / Normal) Low: Brake fluid level is lower than specified level. Normal: Brake fluid level is higher than MIN level.

Parking Brake Sw (Parking brake switch) (ON / OFF) ON: Parking brake lever is pulled up. OFF: Parking lever is released

Rear Defogger Sw (Rear end door window defogger switch) (ON / OFF) This parameter indicates the state of the rear end door window defogger switch.

Tail Light Sw (Lighting switch) (ON / OFF) This parameter indicates the state of the lighting switch.

Driv Seat belt Sw (Driver seat belt switch) (Fasten / Unfasten) This parameter indicates the state of the driver side seat belt buckle switch.

Charge lamp (ON / OFF) This parameter indicates the state of the charge system monitor switch.

Oil pressure switch (ON / OFF) This parameter indicates the state of the oil pressure switch.

A/C Switch (ON / OFF) This parameter indicates the state of the air conditioning switch.

Rear Wiper Sws witch) (ON / INT / OFF) (Rear wiper This parameter indicates the state of the rear wiper switch.

Front Fog Light Sw (Front fog light switch) (ON / OFF) This parameter indicates the state of the front fog light switch.

Headlight Sw (Headlight switch) (ON / OFF) This parameter indicates the state of the lighting switch.

Auto Light Sensor (V) This parameter indicates auto light sensor voltage inputted to BCM.

Auto Light Sw (Auto light switch) (ON / OFF) This parameter indicates the state of the auto light switch.

LED Illumi Contrast (Illumination control of LED) (%) This parameter indicates illumination control percent computed by BCM. (This parameter depends on the illumination controller position)

Bulb Illumi Contrast (Illumination control of bulb) (%) This parameter indicates illumination control percent computed by BCM. (This parameter depends on the illumination controller position)