Manual Transmission/Transaxle: Adjustments

Shift Linkage Adjustment
1. Disconnect the negative battery cable.
2. Position the gearshift lever into NEUTRAL.





3. Loosen the rod clamp bolt.
4. Remove the adjustment hole plug from the shift lever cover.





5. Turn the gearshift rod and fully insert a 5 mm (0.2 inch) gauge pin into the adjustment hole.
6. Remove the boot from the console.
7. Pull the boot upward to expose the shift control lever mechanism.





8. Position the gearshift lever close to left side of the NEUTRAL position.
9. Insert a 5 mm (0.2 inch) gauge pin into the holes to align the gearshift lever with the gearshift lever housing.





10. Tighten the rod clamp bolt.
^ Tighten the rod clamp bolt to 14 Nm (124 inch lbs.).
11. Remove .the 5 mm (0.2 inch) gauge pin from the adjustment hole.
12. Install the adjustment hole plug.
13. Remove the 5 mm (0.2 inch) gauge pin from the gearshift lever.
14. Install the boot to the console.





15. Connect the negative battery cable.