Headlamp Alignment Sensor: Service and Repair

Height Sensor Removal And Installation (If Equipped)

Removal

CAUTION:
- Do not disassemble bracket (4) and link (3) from height sensor (2). Disassemble will spoil its original function. If faulty condition is found, replace it with new one in a set.
- If height sensor was dropped from a height of 30 cm (0.9 ft) or more, replace it with new one.

1. Disconnect negative (-) cable at battery.
2. Disconnect height sensor connector (1) from height sensor (2).
3. Remove height sensor bracket bolts (7) and nuts (8).
4. Remove height sensor (1) with its bracket (4) from suspension frame (6) and lower arm (5).







Installation

For installation, reverse removal procedure noting the following.
- Check that bracket and link of height sensor are not deformed.
- Tighten height sensor bolts and nuts to specified torque.

Tightening torque
Height sensor bracket bolt (a): 10 N.m (1.0 kg-m, 7.5 lbf-ft)
Front height sensor bracket nut (b): 13 N.m (1.3 kg-m, 9.5 lbf-ft)
Rear height sensor bracket nut (c): 10 N.m (1.0 kg-m, 7.5 lbf-ft)







- Connect connector securely.
- After installation, initialize headlight auto leveling system referring to Initialization of Headlight Auto Leveling System.