Programming and Relearning

Power Window System Initialization/Reset (Front Windows Only)

NOTE: Do not pinch any object during initialization/reset operation.

Make sure to conduct initialization/reset of power window when its part is replaced. Auto operation including anti-pinching function will be disabled if initialization/reset of power window is not conducted.

Initialization

1. Push engine switch to change ignition mode of keyless start system to "ON" (with vehicle stopped).
2. Press down and hold power window switch until window glass reaches its fully open position and continue holding it down for additional 2 or more seconds.
3. Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for additional 2 or more seconds.







Resetting after Replacing Front Window Regulator Assembly

1. Push engine switch to change ignition mode of keyless start system to "ON" (with vehicle stopped).
2. Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for about 7 seconds.
3. Push down and hold power window switch until window glass reaches its fully open position (lowest position) and continue holding it down for about 2 seconds.
4. Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for about 2 seconds.