Components Assembly

Shift Control Components: Assembly

1) Install OD fork rod and OD shift fork. Then install new retaining pin into OD shift fork.






CAUTION:
Do not reuse retaining pin.

2) Install 1st and 2nd, 3rd and 4th, and reverse shift forks onto coupling sleeve.
3) Install striking rod into hole of shift forks, striking lever and interlock and then install new retaining pin into striking lever using Tool.











CAUTION:
- Make sure that striking rod moves smoothly.
- Do not reuse retaining pin.

4) Apply sealant to thread of OD and reverse fork rod bolt, and then install OD and reverse fork rod.






- Use Genuine Medium Strength Thread Locking Sealant or the equivalent. Refer to [Recommended Chemical Products and Sealants] Recommended Chemical Products and Sealants.