Rear Door Window Glass: Service and Repair

Rear Door Glass: Removal and Installation

Removal

1) Remove the rear door finisher. Refer to [Door Finisher: Removal and Installation] Service and Repair.
2) Position aside the vapor barrier.
3) Remove the inside seal.
4) Temporarily reconnect the power window switch (if equipped).
5) Remove the glass run from the partition glass.
6) For power windows, operate the power window switch to raise/lower the door window until the glass bolts can be seen.





7) For manual windows, temporarily reinstall the window crank handle and lower the window until the glass bolts can be seen.
8) Remove the partition sash bolt (lower) and screw (upper) to remove the sash.
9) Remove the bolts and the glass.

Installation

Installation is in the reverse order of removal.






- Check the glass alignment. Follow the FITTING INSPECTION procedure.

Fitting Inspection

- Check that the glass fits securely into the glass run groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and glass carrier plate bolts to adjust the glass position.