Inspection

Planetary Gear and Output Shaft Inspection

Planetary Gear and Output Shaft Disassembly and Reassembly

- Check that sliding surface of discs and plate are not worn or burnt. If necessary, replace them.

NOTE:
- If disc lining is exfoliated, discolored or worn badly, replace all discs.
- If only a part of printed numbers is corroded, replace all discs.
- Before assembling new discs, soak them in A/T fluid for at least 2 hours.






- Measure inside diameter of output shaft bushing. If inside diameter exceeds limit, replace output shaft.

Output shaft bushing inside diameter standard
18.001 - 18.026 mm (0.7087 - 0.7097 in.)