CKP (Crankshaft Position) Sensor Inspection

CKP (Crankshaft Position) Sensor Inspection

CKP (Crankshaft Position) Sensor Removal and Installation
1) Remove CKP sensor. CKP (Crankshaft Position) Sensor Removal and Installation
2) Check the following.
- Check that O-ring (1) is free from damage.
- Check that end face of sensor and signal plate tooth are free from any metal particles and damage.






3) Check CKP sensor as follows.

If faulty condition is found, replace CKP sensor.
a) Connect battery (1) and ohmmeter (3) to CKP sensor as shown in figure.
b) Check that CKP sensor resistance varies as specified below by passing magnetic substance (iron) (2).
If faulty condition is found, replace CKP sensor.

NOTE:
Be sure to keep approximately 1 mm (0.03 in) gap "a" between magnetic substance (iron) and end face of CKP sensor.

CKP sensor resistance
Resistance varies between less than 220 ohms (ON) and infinity (OFF)