Front Seat (Split Type: Passenger's Side)
REMOVAL1. REMOVE SEAT TRACK COVERS
Using a screwdriver, remove the seat track covers.
HINT: Tape the screwdriver tip before use.
2. REMOVE FRONT SEAT
a. Remove the 4 bolts.
b. Disconnect the connector.
c. Remove the front seat.
NOTE: Be careful not to damage the body.
INSTALLATION
1. INSTALL FRONT SEAT
a. Slide the front seat to the rearmost position.
NOTE: Make sure that seat adjuster locks.
b. Connect the connector.
c. Without holding the seat track handle, mount the seat to the vehicle.
NOTE: Be careful not to damage the body.
HINT: If holding the seat track handle, the adjusted most front positions will slip off.
d. Tighten the bolts on the front side temporarily, from the bolt on the inner side tighten them completely.
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
e. Slide the seat to the most front position to install the bolts on the rear side.
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
2. INSTALL SEAT TRACK COVERS