Engine - Accessory Drive Belt Squealing Noise
ENGINEEG026-06
REVISED
Title:
2UZ-FE ACCESSORY
DRIVE BELT NOISE
Models:
'00 - '06 Tundra
April 21, 2006
TSB REVISION NOTICE:
^ July 9, 2007: The Introduction has been updated. Production Change Effective VINs have been updated in the Production Change Information table. In the Repair Procedure steps 12 and 13 and the illustration below step 13 have been updated, and steps 14 - 17 have been renumbered.
Previous versions of this TSB should be discarded.
Introduction
Some customers may experience an abnormal squeal noise from the engine accessory drive belt area, usually during cold start-up. An improved accessory drive belt tensioner, A/C compressor bracket, and revised installation procedure have been developed to address this condition.
Applicable Vehicles
^ 2000 - 2006 model year Tundra vehicles produced BEFORE the Production Change Effective VINs shown below.
Production Change Information
Parts Information
Warranty Information
Applicable Warranty*
This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle's in-service date.
* Warranty application is limited to correction of a problem based upon a customer's specific complaint.
Repair Procedure
1. Remove the engine under cover.
2. Drain the engine coolant.
3. Remove the intake air connector assembly.
4. Remove the radiator fan shroud.
5. Remove the drive belt, fan, fluid coupling, and fan pulley.
6. Without disconnecting the power steering fluid lines, remove the power steering pump.
HINT:
Suspend the power steering pump securely.
7. Remove the drive belt idler pulley.
8. Remove the right hand (RH) No. 3 timing belt cover.
9. Remove the No.2 timing belt cover.
10. Without disconnecting the A/C refrigerant lines, remove the A/C compressor from the mounting bracket.
HINT:
Suspend the A/C compressor securely.
11. Disconnect the A/C compressor mounting bracket.
12. Install the NEW A/C compressor mounting bracket and hand tighten bolts 1 and 2 while holding the bracket forward (refer to illustration).
13. While holding the bracket forward, tighten the A/C compressor mounting bolts in the following sequence: bolt 2, bolt 1, bolt 3.
Torque: 47 N.m (475 kgf.cm, 34 ft.lbf)
14. Remove the accessory drive belt tensioner.
15. Install the NEW accessory drive belt tensioner.
16. Reassemble in the reverse order of disassembly.
17. Refill cooling system.