Check DLC3

Check the DLC3







The vehicle's ECM uses ISO 9141-2 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 9141-2 format.

HINT:
If the display shows "UNABLE TO CONNECT TO VEHICLE" when you have connected the cable of the hand-held tester or the OBD II scan tool to the DLC3, turned the ignition switch ON and operated the hand- held tester or OBD II scan tool, there is a problem on the vehicle side or tool side.
- If the communication is normal when the tool is connected to another vehicle, inspect the DLC3 of the original vehicle.
- If the communication is still impossible when the tool is connected to another vehicle, the problem is probably in the tool itself, so consult the Service Department listed in the tool's instruction manual.