Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Replacement





REMOVAL

1. Run engine at idle with air conditioning on for 10 minutes.
2. Disconnect negative cable from battery.
3. Disconnect clutch lead wire from wiring harness.
4. Recover refrigerant from refrigeration system.
5. Disconnect two flexible hoses from compressor service valves. Cap the open fittings immediately to keep moisture out of the system.
6. Remove the compressor.
a. Loosen the drive belt.
b. Remove the compressor mounting bolts and the compressor.

INSTALLATION

1. Install compressor with mounting bolts.
2. Install drive belt.
a. Install the drive belt to the pulley
b. Tighten the belt with the adjusting bolts drive belts tension at 10 kg (22.0 lb)
New belts 9 - 11 mm (0.35-0.43 in.)
Used belts 11 - 16 mm (0.43 - 0.63 in.)
3. Connect two flexible hoses to compressor service valves.
Torque: Discharge line 20 - 24 Nm (15 - 18 ft-lb)
Suction line 30 - 34 Nm (22 - 25 ft-lb)
4. Connect clutch lead wire to wiring harness.
5. Connect negative cable to battery.
6. Evacuate and charge air conditioning system.
Refill capacity: 650-750 g (23 - 26.5 lb)