Ignition Coil: Service and Repair

Exploded View Distributor:

REMOVAL:

1. Remove distributor from vehicle. Refer to DISTRIBUTOR in this section.

2. Remove the distributor cap from the distributor.

3. Remove the ignition rotor, and dust cover.

Primary Coil Wires Removal:

4. Disconnect the wires from the terminals of the ignition coil.





5. Remove the four retaining screws. Remove ignition coil and dust proof packing.

INSTALLATION:

1. Reinstall coil and packing. Tighten coil retaining screws evenly.

CAUTION: Do not use impact or air tools on ignition coil retaining screws.

2. Reconnect the primary wires to the terminals of the ignition coil.

Primary Coil Wires Install:

NOTE: Ensure the wires are properly inserted into their retaining grooves. Ensure that the wires don't contact the signal rotor or distributor housing.

3. Install the ignition rotor, dust cover, and distributor cap.

4. Install distributor in vehicle. Refer to DISTRIBUTOR in this section.