Ignition Coil: Service and Repair

ASSEMBLY NOTICE: Assembly is in the reverse order of disassembly.

1. REMOVE ROTOR.





2. REMOVE IGNITION COIL DUST COVER.
- Remove the dust cover.
- Remove the dust proof packing.

ASSEMBLY HINT: Use new dust proof packing.

3. REMOVE IGNITION COIL.





- Remove the 2 nuts, and disconnect the 3 wires from the ignition coil terminals.





ASSEMBLY NOTICE:

- When connecting the wires to the ignition coil, insert the wire properly into the groove on the side of the ignition coil.
- Be sure the wires do not contact with signal rotor or distributor housing.





- Remove the 4 screws and ignition coil.





ASSEMBLY NOTICE:

- Apply seal packing to the ignition coil installing surface of the housing as shown in the illustration.
- Seal packing: Part No. 08826-00080 or equivalent