Fuel Pump Removal and Installation
REMOVAL
CAUTION: Do not smoke or work near an open flame when working on the fuel pump.
1. REMOVE REAR SEAT CUSHION
2. REMOVE SERVICE HOLE COVER
HINT: Remove the 4 screws, and disconnect the service hole cover from the floor panel.
Torque: 3.5 N.m (35 kgf.cm, 31 in.lbf)
3. REMOVE FUEL PUMP AND SENDER GAUGE ASSEMBLY
(a) Disconnect the following connector, pipe and hose:
(1) Fuel pump & sender gauge connector
(2) Fuel outlet pipe
(3) Fuel return hose
(b) Remove the 8 bolts.
(c) Remove the fuel pump, sender gauge assembly and gasket.
HINT: Use SST.
Torque: 24 N.m (240 kgf.cm, 17 ft.lbf)
INSTALLATION
Installation is in the reverse order of removal.