Passengers Airbag Assembly
REMOVALNOTICE: If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC, diagnostic trouble codes will be recorded.
1. DISCONNECT AIRBAG CONNECTOR
a. Remove the glove compartment door finish plate inside the instrument panel box.
NOTICE: When handing the airbag connector, take care not to damage the airbag wire harness.
b. Pull up the connector.
c. Disconnect the airbag connector.
2. REMOVE INSTRUMENT PANEL
3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
a. Remove the 3 bolts and 4 nuts and remove the front passenger airbag assembly.
b. Remove the 2 screws and airbag door.
CAUTION:
- Do not store the front passenger airbag assembly with the airbag deployment side facing down
- Never disassemble the front passenger airbag assembly.
INSTALLATION
NOTICE: Never use airbag parts from another vehicle. When replacing parts, replace with new parts.
1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
Install the airbag door and front passenger airbag assembly to the instrument panel.
CAUTION: Make sure that no foreign objects are trapped between the airbag door and bag, and within the module.
NOTICE: If the front passenger airbag assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the front passenger airbag assembly with a new one.
2. INSTALL INSTRUMENT PANEL
Install the 2 bolts to instrument panel reinforcement.
Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
NOTICE:
- Make sure the front passenger airbag assembly is installed to the specified torque.
- When installing the instrument panel, take care that the airbag wire harness does not interfere with other parts and is not pinched between other parts.
- When installing the instrument panel box, carefully pull out the airbag wire harness from the glove compartment upper hole.
3. CONNECT AIRBAG CONNECTOR
a. Connect the airbag connector.
b. Set the connector on the glove compartment door finish plate.
c. Install the glove compartment door finish plate to the instrument panel box.