Programming Procedure

For location of the Keyless Entry System ECU, refer to ECU Mounting Locations.

I. To program (add) a REMOTE CONTROL to the system:

1. Insert the key into ignition switch, and turn it to "ON."

2. Press and hold the ECU's PROGRAMMING SWITCH for over 2 seconds.

The Exterior Lights turn on for 5 seconds.

NOTE:
You must perform the next step within 5 seconds.

3. Press and release a REMOTE CONTROL's top or bottom button.

The Exterior (Tail and Marker) Lights flash once, then turn off.

4. Turn off the ignition. The system will now operate with the REMOTE CONTROL just programmed.

II. To erase all REMOTE CONTROL codes from the system:

1. Insert key into the ignition switch, and turn it to "ON."

2. Press and hold the ECU's PROGRAMMING SWITCH for over 2 seconds.

The Exterior Lights turn on for 5 seconds

NOTE:
You must perform the next step within 5 seconds.

3. Press and hold the ECU's PROGRAMMING SWITCH for over 2 seconds again.

The Exterior (Tail and Marker) Lights flash 3 times, then turn off.

4. Turn off the ignition. All REMOTE CONTROL codes have now been cleared; the system will not work with any REMOTE CONTROL until another one is programmed.