Heater Control Valve: Service and Repair
REMOVAL1. DRAIN ENGINE COOLANT FROM RADIATOR
HINT: It is not necessary to drain out all the coolant
2. DISCONNECT WATER VALVE CONTROL CABLE FROM WATER VALVE
HINT: For installing the control cable refer to "INSTALLATION of A/C CONTROL ASSEMBLY".
3. DISCONNECT WATER HOSES
HINT:
^ Push the water hose onto the heater radiator pipe as far as the ridge on the pipe and install them to the hose clip.
^ Install a hose clip in a position, as shown in the illustration
4. REMOVE WATER VALVE
INSTALLATION
Installation is in the reverse order of removal
AFTER INSTALLATION, ADJUST WATER VALVE CONTROL CABLE
a. Set the temperature control dial at "COOL" position.
b. Set the water valve control lever to "COOL" position and install the control cable and lock the clamp.
HINT: Lock the clamp during lightly pulling the outer cable in the direction shown in the illustration by an arrow.