Rear
REMOVAL
1. Disconnect speed sensor connector.
a. Liftback: Remove the rear seat back and deck trim side panel.
b. Coupe: Remove the luggage compartment trim cover.
c. Disconnect the speed sensor connector, and pull out the sensor wire harness with the grommet.
d. Remove the 2 clamp bolts holding the sensor wire harness from the body and shock absorber.
Torque: 5.0 Nm (44 inch lbs.)
2. Remove the speed sensor from the axle carrier.
Torque: 8.0 Nm (71 inch lbs.)
NOTE: At the time of installation, please refer to the following items.
- There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be installed.
- The sensor is installed flat against the knuckle when you tighten the bolt.
INSTALLATION
Instal in the reverse order of removal. After installation, check speed sensor signal.