Load Compensator: Testing and Inspection

ON-VEHICLE INSPECTION





1. SET REAR AXLE LOAD
Rear axle load (includes vehicle weight): 924 kg (2,033 lb)





2. INSTALL LSPV GAUGE (SST) AND BLEED AIR
SST 09709-29018





3. RAISE FRONT BRAKE FLUID PRESSURE TO FOLLOWING SPECIFICATION AND CHECK REAR BRAKE FLUID PRESSURE





Rear Brake Fluid Pressure:

HINT: The brake pedal should not be depressed twice and/or returned while setting to the specified pressure. Read the value of rear pressure 2 seconds after adjusting the specified fluid pressure.

4. IF NECESSARY, ADJUST FLUID PRESSURE





a. Adjust the fluid pressure by changing the A or B length.
1. Low pressure - Lengthen A, B
2. High pressure- Shorten A, B

HINT: Fluid pressure change for one turn of the lock nut is 100 kPa (1.0 kgf/cm2, 14 psi) and fluid pressure change for 1 mm (0.04 inch) sliding of the adjust bolt within the long hole position is 40 kPa (0.4 kgf/cm2, 6 psi).





b. Torque the lock nut.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
If it cannot be adjusted, replace the valve body.