Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2000 >> Corolla CE Sedan L4-1.8L (1ZZ-FE) >> Repair and Diagnosis >> Windows and Glass >> Windows >> Window Glass >> Back Window Glass >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Back Window Glass: Service and Repair

REMOVAL

1. REMOVE REAR SEAT
2. w/ High-mounted stop light:
REMOVE HIGH-MOUNTED STOP LIGHT




a. Push on the both sides of the cover to release the claws by your hand and remove the cover as shown in the illustration.
b. Remove the stop light, then disconnect the connector.

3. REMOVE ROOF SIDE INNER GARNISH




a. Using a screwdriver, pry loose and remove the garnish.

HINT: Tape the screwdriver tip before use.

b. Employ the same manner described above to the other side.

4. REMOVE TETHER ANCHOR
a. Using a screwdriver, remove the CRS tether anchor cover.

HINT: Tape the screwdriver tip before use.

b. Remove the tether anchor by loosening the bolt.
c. Employ the same manner described above to the other sides.

5. REMOVE PACKAGE TRAY TRIM
6. DISCONNECT DEFOGGER WIRE CONNECTORS
7. REMOVE BACK WINDOW MOULDING




Using a knife, cut off the moulding as shown in the illustration.

NOTE: Do not damage the body with the knife.

8. REMOVE BACK WINDOW GLASS
Remove the glass in the same way as windshield.

INSTALLATION

HINT: Refer to the installation of the windshield and install the back window glass by the following operations.

1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
2. REPLACE STOPPER
a. Remove the damaged stoppers.
b. Cut off the old adhesive around the stopper installation area.
c. Clean the installation area.




d. Install new stoppers on the glass as shown in the illustration.

3. CLEAN REMOVED GLASS
4. CLEAN CONTACT SURFACE OF GLASS
5. COAT CONTACT SURFACE OF BODY WITH PRIMER "M"
6. COAT CONTACT SURFACE OF GLASS WITH PRIMER "G"
7. APPLY ADHESIVE
8. INSTALL BACK WINDOW GLASS
9. INSPECT FOR LEAK AND REPAIR
a. Do a leak test after the hardening time has elapsed.
b. Seal any leak with sealant.

Part No.08833-00030 or equivalent

10. APPLY ADHESIVE AT MOULDING INSTALLATION AREA
11. INSTALL BACK WINDOW MOULDING
12. CONNECT DEFOGGER WIRE CONNECTORS
13. INSTALL PACKAGE TRAY TRIM
14. INSTALL TETHER ANCHOR
a. Install the tether anchor by tightening the bolt.
b. Install the CRS tether anchor cover to the tether anchor.
c. Employ the same manner described above to the other sides.

15. INSTALL ROOF SIDE INNER GARNISHES




16. w/ High-mounted stop light:
INSTALL HIGH-MOUNTED STOP LIGHT

a. Connect the connector, then install the stop light.
b. Push on the both side of the cover to engage the claws by your hand and install the cover as shown in the illustration.

17. INSTALL REAR SEAT
pro multis · About Operation CHARM