Cylinder Head Torque & Sequence

Tightening Specifications

Cylinder Head Bolts
1st Pass 29.4 Nm
2nd Pass 90 degrees
3rd Pass 90 degrees

NOTE: If any cylinder head bolt is broken or deformed, replace it. Apply a light coat of engine oil on the threads and under the heads of the cylinder head bolts.

Camshaft Bearing Cap Bolts
No. 1 23 Nm
No. 2 12.7 Nm

NOTE: Install and uniformly tighten the 19 bearing cap bolts. After tightening the No.1 camshaft bearing cap, tighten then in several passes, in the sequence shown.