Power Slide Door Control System

FOR VEHICLES EQUIPPED WITH POWER SLIDE DOOR CONTROL SYSTEM

When the battery is disconnected or the power to the power slide door motor is cut, the power slide door control system does not operate. It is necessary to initialize the system in the following procedures. Otherwise slide door cannot be operated normally.
1. Disconnect the battery negative (-) terminal for more than 1 mm., and install it.
2. Close the RH slide door manually.
3. Push the power slide door MAIN switch ON and wait for 5 secs.
4. Fully open the slide door by the power slide door control switch and wait for 3 secs.
5. Fully close the slide door by the power slide door control switch and wait for 3 secs.
6. Repeat the step (4) and (5).