Removal and Replacement
REMOVAL1. REMOVE ROOF HEADLINING
2. REMOVE SLIDING ROOF GLASS
a. Remove the 4 screws.
b. Pull the glass upward to remove it.
3. REMOVE DRIVE GEAR
NOTE: Remove the drive gear with the sliding roof fully closed.
a. Remove the 2 screws and room light bracket.
b. Disconnect the connector.
c. Remove the 2 bolts and drive gear.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
4. REMOVE SLIDING ROOF HOUSING
a. Disconnect the 4 drain hoses from the housing.
b. Remove the 12 bolts and 6 brackets.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
c. Remove the 4 nuts, then remove the housing.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installing the sliding roof, sliding roof need to be re-initialized.