On-Vehicle Inspection

ON-VEHICLE INSPECTION

1. DOOR LOCK FAIL-SAFE
a. When a malfunction in the door control switch (manual switch, interlocked with key operation) has been detected, door lock/unlock operations become unable.

2. INSPECT FOR ELECTRICAL DOOR LOCK OPERATION

NOTE: Initial condition that the customizing function by TOYOTA hand-held tester is not chosen is shown.

a. Basic Function Check
1. Check all doors will lock when the door control switch (for manual operation) is turned to the lock side and all doors will unlock when turned to the unlock side.
2. Check all doors will lock when the driver's door is operated to be lock and all doors will unlock when operated to be unlock, by the key operation outside the vehicle.

b. Key Confinement Prevention Function Check

NOTE: In order to prevent the key from confined, the inspection should be made with the driver's door glass open.

1. Have the ignition key inserted into the ignition switch lock cylinder.
2. With the driver's door open, check all doors will immediately unlock when the door lock knob for the driver's door is turned toe the lock side.
3. With the driver's door open, check that all doors will immediately unlock when the door control switch (for manual operation) is turned to the lock side.
4. With the driver's door open, make the driver's door lock by holding the driver's door lock knob in the lock side for 2 seconds or more and then close the driver's door. Then, check that all doors will unlock.

c. Security Function Check
1. Close all doors with the driver's door glass open so that the door control switch can be operated outside the vehicle.
2. Pull out the ignition key, open the driver's door and close lock the door without a key operation. Under this condition, check that all doors will not unlock when the door control switch (for manual operation) is turned to the unlock side outside the vehicle.
3. Pull out the ignition key, close and lock the driver's door by a key operation. Under this condition, check that all doors will not unlock when the door control switch (for manual operation) is turned to the unlock side outside the vehicle.
4. Pull out the ignition key, close the driver's door and lock the door by a wireless door lock operation. Under this condition, check that all doors will not unlock when the door control switch for manual operation) is turned to the unlock side outside the vehicle.

HINT:
- Under the conditions below, check that the security function will cancel
- Ignition switch turned ON.
- Driver's door unlocked by a key operation.
- Door control switch (for manual operation) turned to the unlock side after the door control knob have been unlocked manually
- Doors unlocked by a wireless operation.

d. Illumination Function Check
1. Make the map light switch in the DOOR position.
2. Check that the map light will be on simultaneously wit hall door's unlocking operation when the driver's door of all the closing doors is turned to the unlock side by a key operation.
3. Map light will be off in approximately 15 seconds if a door has not been opened for a while.