Transmission Temperature Sensor/Switch: Service and Repair
ON-VEHICLE REPAIR1. REMOVE ENGINE NO.2 UNDER COVER
2. DRAIN ATF
3. REMOVE OIL PAN
4. REMOVE OIL STRAINER
5. REMOVE ATF TEMPERATURE SENSOR
a. Disconnect the 7 solenoid valve connectors.
b. Remove the 2 bolts and disconnect the 2 ATF temperature sensors.
c. Disconnect the solenoid connector.
d. Remove the bolt and the transmission wire harness.
6. INSTALL ATF TEMPERATURE SENSOR
a. Install the transmission wire harness.
b. Install the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
c. Connect the solenoid connector.
d. Connect the 7 solenoid valve connectors.
e. Connect the 2 ATF temperature sensors with the 2 bolts.
Torque:
A: 11 Nm (112 kgf-cm, 8 ft. lbs.)
B: 10 Nm (100 kgf-cm, 7 ft. lbs.)
Bolt length:
Bolt A: 36 mm (1.42 inch)
Bolt B: 12 mm (0.47 inch)
Sensor wire harness
7. INSTALL OIL STRAINER
8. INSTALL OIL PAN
9. FILL ATF AND CHECK ATF LEVEL
10. INSTALL ENGINE NO.2 UNDER COVER