Removal and Installation

REMOVAL

1. DISCONNECT WIRING FROM GENERATOR
a. Disconnect the connector from the generator.
b. Remove the nut and disconnect the wire from the generator.
c. Disconnect the cord clamp from the generator.




2. REMOVE GENERATOR DRIVE BELT
a. Loosen the adjust lock nut, adjusting bolt and pivot bolt.
b. Remove the drive belt.

3. REMOVE GENERATOR
a. Remove the pivot bolt, adjusting lock nut, adjusting bolt and adjusting slider.
b. Remove the generator.

INSTALLATION




1. INSTALL GENERATOR
a. Place the generator to the generator bracket.
b. Temporarily install the pivot bolt, adjusting slider, adjusting bolt and adjusting lock nut.

2. INSTALL AND ADJUST GENERATOR DRIVE BELT
a. Install the generator drive belt.
b. Adjust the generator drive belt tension with the adjusting bolt.
c. Torque the pivot bolt and lock nut.

Torque:
Pivot bolt: 51 N.m (520 kgf.cm, 38 ft.lbf)
Lock Nut: 18.5 N.m (185 kgf.cm, 14 ft.lbf)

3. CONNECT WIRING TO GENERATOR
a. Connect the cord clamp to the generator.
b. Connect the wire to the generator with the nut.
c. Connect the connector to the generator.