Clutch Switch: Testing and Inspection

CLUTCH START SWITCH ASSY (MTM)
ON-VEHICLE INSPECTION





1. CHECK CLUTCH START SYSTEM
a. Check that the engine does not start when the clutch pedal is released.
b. Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assy.

INSPECTION








1. INSPECT CLUTCH START SWITCH ASSY
a. Check the continuity between the terminals when switch is ON and OFF.
Switch position Condition
ON (pushed) Continuity
OFF (free) No continuity

REPLACEMENT
1. REMOVE CLUTCH START SWITCH ASSY
a. Disconnect the clutch start switch assy connector.
b. Remove the nut and clutch start switch assy from the clutch pedal support.
2. INSTALL CLUTCH START SWITCH ASSY
a. Install the clutch start switch assy with the nut.
Torque: 15.68 Nm (160 kgf-cm, 12 ft. lbs.)
b. Connect the clutch start switch assy connector.
3. INSPECT CLUTCH START SWITCH ASSY