Component Inspection

INSPECT MAGNETIC CLUTCH CLEARANCE
a. Set the dial indicator to the magnetic clutch hub.
b. Connect the battery positive lead to terminal 3 of the magnetic clutch connector and the negative lead to the earth wire. Turn on and off the magnetic clutch and measure the clearance.

Standard clearance: 0.26 to 0.60 mm (0.010 to 0.024 in.)

If the measured value is out of the standard range, remove the magnetic clutch hub and adjust it with the magnetic clutch washers.

NOTE: Adjustment shall be performed with 3 or less magnetic clutch washers.

c. Remove the compressor and magnetic clutch from the vise.