Rear Wheel Alignment

NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).

REAR WHEEL ALIGNMENT (FF)
INSPECTION
1. INSPECT TIRE
2. MEASURE VEHICLE HEIGHT

NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.

3. INSPECT TOE-IN

Toe-In:

If the toe-in is not within the specified value, inspect and replace the suspension parts as necessary.

4. INSPECT CAMBER
a. Install the camber-caster-kingpin gauge or position vehicle on wheel alignment tester.
b. Inspect the camber.

Camber:

If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear and replace them if necessary because camber is not adjustable.