Removal and Installation

GENERATOR

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE FAN AND GENERATOR V BELT
a. Remove the belt.







3. REMOVE GENERATOR ASSEMBLY
a. Disconnect the generator connector.
b. Remove the terminal cap.
c. Remove the nut and disconnect the generator wire.
d. Remove the bolt and wire harness clamp bracket.
e. Remove the wire harness clamps.
f. Remove the 2 bolts and generator.

INSTALLATION




1. INSTALL GENERATOR ASSEMBLY
a. Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.




b. Install the generator with the 2 bolts.

Torque: 21 N.m (215 kgf.cm, 16 ft.lbf) for bolt A
52 N.m (530 kgf.cm, 38 ft..lbf) for bolt B




c. Install the wire harness clamp.
d. Install the wire harness clamp bracket with the bolt.

Torque: 8.4 N.m (85 kgf.cm, 74 in.lbf)

e. Connect the generator wire with the nut.

Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf)

f. Install the terminal cap.
g. Connect the generator connector.

2. INSTALL FAN AND GENERATOR V BELT
a. Install the belt.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL