Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2007 >> Camry L4-2.4L (2AZ-FXE) Hybrid >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Fuel Tank Pressure Sensor >> Service and Repair >> Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal








2AZ-FXE EMISSION CONTROL: FUEL TANK PRESSURE SENSOR: REMOVAL

REMOVAL

1. REMOVE FUEL TANK CAP ASSEMBLY

HINT: Removal

2. REMOVE REAR SEAT CUSHION ASSEMBLY Removal
3. REMOVE REAR FLOOR SERVICE HOLE COVER Removal
4. REMOVE VAPOR PRESSURE SENSOR ASSEMBLY





(a) Disconnect the connector.





(b) Remove the cover and tube joint clip, and pull out the vapor pressure sensor.

NOTICE:
- Before this operation, check that there is no dirt or other foreign objects around the connector. Clean the connector if necessary.
- It is necessary to prevent mud or dirt from entering the connector. If mud or dirt gets in the connector, the O-ring may not seal properly.
- Do not use any tools for this operation.
- If the fuel suction plate and vapor pressure sensor are stuck, carefully try wiggling or pushing and pulling on the vapor pressure sensor to release it. Pull the sensor off the suction plat carefully.
pro multis · About Operation CHARM