Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2007 >> Sequoia 2WD V8-4.7L (2UZ-FE) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Sensors and Switches - Computers and Control Systems >> Transmission Position Sensor/Switch >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Transmission Position Sensor/Switch: Service and Repair

PARK/ NEUTRAL POSITION SWITCH

REMOVAL
1. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR





2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Pry off the lock washer and remove the nut.
b. Remove the bolt and park/neutral position switch.

ADJUSTMENT





1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Loosen the park/neutral position switch bolt and move the shift lever to N.
b. Align the switch groove with the neutral basic line.
c. Hold the switch in position and tighten the bolt.
Torque: 13 Nm (1,130 kgf-cm, 10 ft. lbs.)

INSTALLATION





1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Install the park/neutral position switch with the bolt.
Torque: 13 Nm (1,130 kgf-cm, 10 ft. lbs.)
b. Install a new lock washer and the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
c. Bend the claws on the lock washer to stake the nut.
d. Adjust the park/neutral position switch.

2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
pro multis · About Operation CHARM