Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2007 >> Tacoma 2WD L4-2.7L (2TR-FE) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Oxygen Sensor >> Service and Repair >> Heated Oxygen Sensor
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Heated Oxygen Sensor

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL




2. REMOVE HEATED OXYGEN SENSOR
a. Disconnect the heated oxygen sensor connector.
b. Disconnect the wire harness clamp. (4WD DRIVE TYPE)




c. Using SST, remove the heated oxygen sensor.

SST 09224-00010

INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR




a. Using SST, install the heated oxygen sensor.

SST 09224-00010

Torque:
44 N.m (449 kgf.cm, 33 ft.lbf)
40 N.m (408 kgf.cm, 30 ft.lbf) with SST

NOTE: Use a torque wrench with a fulcrum length of 300 mm (11.81 in.)

b. Connect the wire harness clamp. (4WD DRIVE TYPE)
c. Connect the oxygen sensor connector.




2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)

3. CHECK FOR EXHAUST GAS LEAKAGE
pro multis · About Operation CHARM