Steering Angle Sensor: Service and Repair

REMOVAL

1. PRECAUTION
Refer to Restraint Systems Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
a. Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING WHEEL COVER LOWER NO. 2
5. REMOVE STEERING WHEEL COVER LOWER NO. 3
6. REMOVE STEERING PAD ASSEMBLY
7. REMOVE STEERING WHEEL ASSEMBLY
8. REMOVE STEERING COLUMN COVER LOWER
9. REMOVE STEERING COLUMN COVER UPPER
10. REMOVE SPIRAL CABLE




11. REMOVE STEERING SENSOR
a. Release 6 claw fittings and remove the steering sensor from the spiral cable.

INSTALLATION

1. INSTALL STEERING SENSOR




a. Install the steering sensor onto the spiral cable.

NOTE:
- Engage the claws securely.
- Be careful not to damage the claws.

2. REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. INSTALL SPIRAL CABLE
4. CENTER SPIRAL CABLE
5. INSTALL STEERING COLUMN COVER UPPER
6. INSTALL STEERING COLUMN COVER LOWER
7. INSTALL STEERING WHEEL ASSEMBLY
8. INSTALL STEERING PAD ASSEMBLY
9. INSTALL STEERING WHEEL COVER LOWER NO. 3
10. INSTALL STEERING WHEEL COVER LOWER NO.2
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)

12. INSPECT STEERING PAD ASSEMBLY
13. INSPECT SRS WARNING LIGHT