Control Module: Service and Repair
4WD CONTROL ECUCOMPONENTS:
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE RH (for Regular Cab)
(a) Remove the front door scuff plate RH.
HINT: Use the same procedures described for the LH side.
2. REMOVE FRONT DOOR SCUFF PLATE RH (for Double Cab)
(a) Remove the front door scuff plate RH.
HINT: Use the same procedures described for the LH side.
3. REMOVE COWL SIDE TRIM BOARD RH
(a) Remove the cowl side trim board RH.
HINT: Use the same procedures described for the LH side.
4. REMOVE INSTRUMENT SIDE PANEL RH
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
6. REMOVE 4WD CONTROL ECU
(a) Disconnect the 2 ECU connectors.
(b) Remove the bolt and ECU.
INSTALLATION
1. INSTALL 4WD CONTROL ECU
(a) Install the ECU with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
(b) Connect the 2 ECU connectors.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
3. INSTALL INSTRUMENT SIDE PANEL RH
4. INSTALL COWL SIDE TRIM BOARD RH
(a) Install the cowl side trim board RH.
HINT: Use the same procedures described for the LH side.
5. INSTALL FRONT DOOR SCUFF PLATE RH (for Regular Cab)
(a) Install the front door scuff plate RH.
HINT: Use the same procedures described for the LH side.
6. INSTALL FRONT DOOR SCUFF PLATE RH (for Double Cab)
(a) Install the front door scuff plate RH.
HINT: Use the same procedures described for the LH side.