Removal

U151E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

2. REMOVE BATTERY

3. REMOVE COOL AIR INTAKE DUCT SEAL

4. REMOVE NO. 2 AIR CLEANER INLET

5. REMOVE NO. 1 AIR CLEANER INLET

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

9. REMOVE AIR CLEANER BRACKET

10. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Remove the nut from the control shaft lever.
(b) Disconnect the control cable from the control shaft lever.

(c) Remove the clip and disconnect the control cable from the control cable bracket.
NOTE: Do not hold the resin guide pipe.

11. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Disconnect the park/neutral position switch connector.

(b) Remove the nut, washer and the control shaft lever.

(d) Remove the lock nut and the lock plate.

(e) Remove the 2 bolts and pull out the park/neutral position switch.