Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2008 >> Matrix L4-1.8L (1ZZ-FE) >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Skid Control Sensor >> Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal










BRAKE CONTROL: SKID CONTROL SENSOR:

COMPONENTS









REMOVAL

HINT: Replace the RH side by the same procedure as the LH side.

1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type)
4. REMOVE REAR DISC (for Disc Type)
5. DISCONNECT SKID CONTROL SENSOR WIRE





(a) Disconnect the skid control sensor wire connector from the skid control sensor.
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (Removal)

7. REMOVE SKID CONTROL SENSOR





(a) Mount the rear axle hub in a soft jaw vise.

NOTE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.

(b) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
(c) Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST: 09520-00031
09520-00040
SST: 09521-00020
SST: 09950-00020

NOTICE:
- If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
- Do not scratch the contacting surface of axle hub and speed sensor.
pro multis · About Operation CHARM