Rear Wheel Alignment

SUSPENSION: REAR WHEEL ALIGNMENT:

NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).

INSPECTION

1. INSPECT TIRE
(a) Inspect the tires (Component Tests and General Diagnostics).
2. MEASURE VEHICLE HEIGHT
(a) Measure the vehicle height (Service and Repair).





3. INSPECT TOE-IN
Standard toe-in:





- Measure "C - D" only when "A + B'" cannot be measured.
- If the toe-in is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.

4. INSPECT CAMBER
(a) Install the camber-caster-kingpin gauge or set the vehicle on a wheel alignment tester.
(b) Inspect the camber.
Standard camber:





HINT: Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.