Installation

2AZ-FXE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR





(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.





(b) Install the crankshaft position sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
(c) Connect the crankshaft position sensor connector.
2. INSTALL ELECTRIC INVERTER COMPRESSOR Installation
3. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE Installation
4. CONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE Installation
5. CONNECT RADIATOR HOSE OUTLET Installation
6. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY Installation
7. INSTALL V-RIBBED BELT Installation
8. INSTALL V-RIBBED BELT TENSIONER COVER SUB-ASSEMBLY Installation
9. INSTALL SERVICE PLUG GRIP Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. ADD ENGINE COOLANT (for Engine) Testing and Inspection
12. INSPECT FOR COOLANT LEAK (for Engine) Testing and Inspection
13. CHARGE WITH REFRIGERANT Service and Repair
14. WARM UP COMPRESSOR Service and Repair
15. INSPECT FOR REFRIGERANT LEAK Service and Repair
16. PERFORM INITIALIZATION
(a) Perform initialization procedure Repair Instruction - Initialization.
NOTICE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.