Removal

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: REMOVAL

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal
2. REMOVE ENGINE UNDER COVER LH
3. REMOVE ENGINE UNDER COVER RH
4. DRAIN ENGINE COOLANT Testing and Inspection
5. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Removal
6. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Removal
7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal
8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal
9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal
10. REMOVE WINDSHIELD WIPER MOTOR AND LINK Removal
11. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY Removal
12. REMOVE COOL AIR INTAKE DUCT SEAL Removal
13. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
14. REMOVE AIR CLEANER INLET ASSEMBLY Removal
15. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal
16. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal
17. REMOVE NO. 1 AIR CLEANER INLET Removal
18. REMOVE INTAKE AIR SURGE TANK Removal
19. SEPARATE FUEL TUBE SUB-ASSEMBLY Removal
20. REMOVE INTAKE MANIFOLD Removal
21. REMOVE KNOCK CONTROL SENSOR





(a) Disconnect the 2 knock control sensor connectors.
(b) Remove the 2 bolts and 2 knock control sensors.