Removal

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

REMOVAL

1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair
2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
3. REMOVE ENGINE UNDER COVER ASSEMBLY Removal
4. REMOVE NO. 1 ENGINE UNDER COVER Removal
5. DRAIN ENGINE COOLANT Service and Repair
6. REMOVE COOL AIR INTAKE DUCT SEAL Removal
7. REMOVE BATTERY Removal
8. REMOVE NO. 2 AIR CLEANER INLET Removal
9. REMOVE NO. 1 AIR CLEANER INLET Removal
10. DISCONNECT NO. 1 RADIATOR HOSE Removal
11. DISCONNECT NO. 2 RADIATOR HOSE Removal
12. DISCONNECT OIL COOLER HOSE Removal
13. DISCONNECT COOLING FAN ECU CONNECTOR Removal
14. REMOVE RADIATOR GRILLE Removal
15. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch) Removal
16. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch) Removal
17. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY Removal
18. SEPARATE COOLER CONDENSER ASSEMBLY Removal
19. REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR Removal
20. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal
21. DISCONNECT SUCTION HOSE SUB-ASSEMBLY Removal
22. REMOVE COMPRESSOR AND MAGNETIC CLUTCH Removal
23. REMOVE CRANKSHAFT POSITION SENSOR





(a) Disconnect the crankshaft position sensor connector.
(b) Remove the bolt and crankshaft position sensor.