Installation

2GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.





(b) Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the crankshaft position sensor connector.
2. TEMPORARILY TIGHTEN COMPRESSOR AND MAGNETIC CLUTCH Installation
3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH Installation
4. CONNECT SUCTION HOSE SUB-ASSEMBLY Installation
5. CONNECT DISCHARGE HOSE SUB-ASSEMBLY Installation
6. INSTALL RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR Installation
7. INSTALL COOLER CONDENSER ASSEMBLY Installation
8. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY Installation
9. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch) Installation
10. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch) Installation
11. INSTALL RADIATOR GRILLE Installation
12. CONNECT COOLING FAN ECU CONNECTOR Installation
13. CONNECT OIL COOLER HOSE Installation
14. CONNECT NO. 2 RADIATOR HOSE Installation
15. CONNECT NO. 1 RADIATOR HOSE Installation
16. INSTALL NO. 1 AIR CLEANER INLET Installation
17. INSTALL NO. 2 AIR CLEANER INLET Installation
18. INSTALL BATTERY Installation
19. INSTALL COOL AIR INTAKE DUCT SEAL Installation
20. CHARGE WITH REFRIGERANT Service and Repair
21. ADD ENGINE COOLANT Service and Repair
22. INSPECT FOR COOLANT LEAK Testing and Inspection
23. INSPECT AUTOMATIC TRANSAXLE FLUID
HINT:

24. INSPECT FOR OIL LEAK
25. WARM UP ENGINE Service and Repair
26. INSPECT FOR REFRIGERANT LEAK Service and Repair
27. INSTALL NO. 1 ENGINE UNDER COVER Installation
28. INSTALL ENGINE UNDER COVER ASSEMBLY Installation
29. INSTALL V-BANK COVER SUB-ASSEMBLY Installation