Removal

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: REMOVAL

REMOVAL

1. REMOVE ENGINE UNDER COVER ASSEMBLY Removal
2. REMOVE NO. 1 ENGINE UNDER COVER Removal
3. DRAIN ENGINE COOLANT Service and Repair
4. DISCHARGE FUEL SYSTEM PRESSURE Removal
5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal
6. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal
7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal
8. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal
9. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY Removal
10. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
11. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal
12. DISCONNECT ENGINE ROOM MAIN WIRE Removal
13. REMOVE THROTTLE BODY BRACKET Removal
14. REMOVE NO. 1 SURGE TANK STAY Removal
15. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal
16. REMOVE NO. 2 ENGINE MOUNTING STAY RH Removal
17. DISCONNECT FUEL MAIN TUBE Removal
18. REMOVE INTAKE MANIFOLD Removal
19. REMOVE KNOCK CONTROL SENSOR





(a) Disconnect the 2 knock control sensor connectors.
(b) Remove the 2 bolts and then remove the 2 knock control sensors.