Installation

2GR-FE ENGINE CONTROL SYSTEM: VVT SENSOR: INSTALLATION

INSTALLATION

1. INSTALL VVT SENSOR (for Bank 2)
(a) Exhaust side:




(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Intake side:




(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL VVT SENSOR (for Bank 1)
(a) Exhaust side:




(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Intake side:




(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL HARNESS PROTECTOR Installation
4. TEMPORARILY INSTALL NO. 1 SURGE TANK STAY Installation
5. TEMPORARILY INSTALL THROTTLE BODY BRACKET Installation
6. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation
7. FULLY TIGHTEN NO. 1 SURGE TANK STAY Installation
8. FULLY TIGHTEN THROTTLE BODY BRACKET Installation
9. CONNECT ENGINE ROOM MAIN WIRE Installation
10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
11. ADD ENGINE COOLANT Service and Repair
12. INSPECT FOR COOLANT LEAK Testing and Inspection
13. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation
14. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Installation
15. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
16. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
17. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
18. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
19. INSTALL NO. 1 ENGINE UNDER COVER Installation
20. INSTALL ENGINE UNDER COVER ASSEMBLY Installation